Sierra 2500 4WD V8-6.6L DSL Turbo (2007)
Axle Bearing: Service and Repair
Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Drum)
Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Drum)
Tools Required
*
J 8092 Universal Driver Handle-3/4 in - 10
*
J 21128 Axle Pinion Oil Seal Installer
*
J 23690 Axle Shaft Bearing Installer
*
J 2619-01 Slide Hammer
*
J 44685 Rear Axle Seal and Bearing Remover
Removal Procedure
1. Remove the axle shaft.
2. Remove the axle shaft seal and the bearing from the axle housing using the J 44685 (1) and the J 2619-01 (2).
Installation Procedure
1. Install the axle shaft bearing using the J 23690 (1) and the J 8092 (2).
2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.