Sierra 2500 4WD V8-6.6L DSL Turbo (2007)
2. Position the wheel stud in the rear axle hub.
3. Using washers and a wheel nut, tighten the wheel nut until the wheel stud is fully seated in the rear axle hub.
4. Remove the lug nut and the washers.
5. Lubricate the following with a light coat of high melting point EP bearing lubricant:
^
The outer wheel bearing
^
The inner wheel bearing
^
The outer wheel bearing cup
^
The inner wheel bearing cup
^
The axle hub spindle
6. Install the outer bearing into the rear axle hub.
