Sierra 2500 4WD V8-6.6L DSL Turbo (2007)
Important: When installing the flywheel, ensure that the tapered side of the teeth are facing the starter.
1. Install the flywheel.
2. Install the flywheel washer with the beveled side facing the engine.
Notice: Refer to Fastener Notice.
Notice: This component uses bolts with a preapplied molybdenum disulfide coating for thread lubrication. Do not remove the coating or use any
additional lubricant. Improperly lubricated threads will adversely affect the bolt torque and clamp load. Improper bolt torque and clamp load can
lead to engine damage.
3. Install NEW flywheel bolts.
4. Tighten the flywheel bolts in the proper sequence.
1. Tighten the bolts a first pass to 79 N.m (58 lb ft).
2. Tighten the bolts a second pass to 60 degrees using J 45059.
3. Tighten the bolts a final pass an additional 60 degrees using J 45059.
