Sierra 2500 Denali 2WD V8-6.0L (2011)
10. Install the inner (1) and outer (2) disc brake pads.
11. Prepare the brake caliper bracket bolts and the rear axle threaded holes for assembly.
*
Thoroughly clean the brake caliper bracket bolts of any threadlocker residue.
*
Thoroughly clean the rear axle threaded holes of any threadlocker residue with denatured alcohol and allow to dry.
12. Apply threadlocker GM P/N 89021297 (Canadian P/N 10953488) to 2/3 of the threaded length of the brake caliper bracket bolt.
13. Allow the threadlocker to cure approximately 10 minutes before assembly.
14. Install the brake caliper and bracket assembly to the steering knuckle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
15. Install the brake caliper bracket bolts (1) and tighten to 300 Nm (221 lb ft).
16. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
17. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
18. Slowly release the brake pedal.
19. Wait 15 seconds, then repeat steps 17-18 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
