Sierra 2500 Denali 2WD V8-6.0L (2011)
5. Install the brake caliper bracket (1) to the disc brake caliper.
6. Ensure the brake caliper guide pin boots are fully seated in the groove of the brake caliper bracket.
7. Install the disc brake pads. Refer to Rear Disc Brake Pads Replacement (JD9) (See: Disc Brake System/Brake Pad/Service and Repair/Removal
and Replacement/Rear Disc Brake Pads Replacement (JD9))Rear Disc Brake Pads Replacement (J90, J95, J96) (See: Disc Brake System/Brake
Pad/Service and Repair/Removal and Replacement/Rear Disc Brake Pads Replacement (J90, J95, J96)).
8. Prepare the brake caliper bracket bolts and the rear axle threaded holes for assembly.
*
Thoroughly clean the brake caliper bracket bolts of any threadlocker residue.
*
Thoroughly clean the rear axle threaded holes of any threadlocker residue with denatured alcohol and allow to dry.
9. Apply threadlocker GM P/N 89021297 (Canadian P/N 10953488) to 2/3 of the threaded length of the brake caliper bracket bolt.
10. Allow the threadlocker to cure approximately 10 minutes before assembly.
11. Install the brake caliper and bracket assembly (1) to the rear axle.
