Sierra 2500 Denali 2WD V8-6.0L (2011)
Note: The upper brake caliper guide pin is equipped with a bushing and must be installed in the same position.
2. Install the upper brake caliper guide pin (1), the lower brake caliper guide pin (2), and the brake caliper guide pin collars (3).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Tighten the brake caliper guide pins to 105 Nm (77 lb ft).
4. Install the rear brake caliper bracket (1).
5. Ensure the brake caliper guide pin seals are fully seated in the grooves on the brake caliper and the brake caliper bracket.
6. Install the rear disc brake pads. Refer to Rear Disc Brake Pads Replacement (JD9) (See: Disc Brake System/Brake Pad/Service and
Repair/Removal and Replacement/Rear Disc Brake Pads Replacement (JD9))Rear Disc Brake Pads Replacement (J90, J95, J96) (See: Disc
Brake System/Brake Pad/Service and Repair/Removal and Replacement/Rear Disc Brake Pads Replacement (J90, J95, J96)).
