Sierra 2500 Denali 2WD V8-6.0L (2011)
13. Install the oil pan-to-front cover bolts (1) until snug. Do not over tighten.
14. Install J 41476 to the front cover.
15. Align the tapered legs of the J 41476 with the machined alignment surfaces on the front cover.
16. Install the crankshaft balancer bolt until snug. Do not overtighten.
1. Tighten the oil pan to front cover bolts to 25 Nm (18 lb ft).
2. Tighten the engine front cover bolts to 25 Nm (18 lb ft).
17. Remove the J 41476 .
18. Connect the engine harness electrical connector (1) to the CMP sensor wire harness electrical connector.
19. Install a NEW crankshaft front oil seal. Refer to Crankshaft Front Oil Seal Replacement (Except LY6, L76 and L9H) (See: Seals and
Gaskets/Front Crankshaft Seal/Service and Repair)Crankshaft Front Oil Seal Replacement (LY6, L76 and L9H) (See: Seals and Gaskets/Front
Crankshaft Seal/Service and Repair).