Sierra 2500 Denali 2WD V8-6.0L (2011)
17. Unsecure and position the EVAP canister vent solenoid clip (1) to the chassis EVAP line.
18. Install the EVAP canister vent solenoid pipe clip (2) from the chassis EVAP line.
19. If equipped with 4WD, install the fuel hose/pipe clip to the bracket on the transfer case.
20. Install the fuel line clip to the bracket on the automatic transmission.
21. Install the fuel pipe bracket nut to the bellhousing stud.
Tighten the nut to 25 Nm (18 lb ft).
22. Position and install the front propeller shaft, if required. Refer to Front Propeller Shaft Replacement (See: Transmission and
Drivetrain/Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Front Propeller Shaft Replacement).
23. Lower the vehicle.
