Sierra 2500 Denali 2WD V8-6.0L (2011)
13. Install the fuel pipe bracket nut to the bellhousing stud. Tighten the nut to 25 Nm (18 lb ft).
14. Position and install the BPMV. Refer to Brake Pressure Modulator Valve Replacement (See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Brake Pressure Modulator Valve Replacement).
15. Position and install the front propeller shaft, if required. Refer to Front Propeller Shaft Replacement (See: Transmission and
Drivetrain/Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Front Propeller Shaft Replacement).
16. Lower the vehicle.
17. Remove the caps from the fuel rail and EVAP line.
18. Connect the EVAP line (1) quick connect fitting to the chassis EVAP line. Refer to Plastic Collar Quick Connect Fitting Service (See: Fuel Line
Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
19. Connect the fuel feed line (2) quick connect fitting to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service (See: Fuel Line
Coupler/Service and Repair/Metal Collar Quick Connect Fitting Service).
20. Install the fuel fill cap.
21. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) (See: Starting and
Charging/Battery/Battery Cable/Negative/Service and Repair)Battery Negative Cable Disconnection and Connection (TP2) (See: Starting and
Charging/Battery/Battery Cable/Negative/Service and Repair).
22. Use the following procedure in order to inspect for leaks:
