Sierra 2500 Denali 2WD V8-6.0L (2011)
1. If installing the old sensor, coat the threads with sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the ECT sensor and tighten to 20 Nm (15 lb ft).
3. Connect the engine wiring harness electrical connector (2) to the ECT sensor.
4. Refill the cooling. Refer to Cooling System Draining and Filling (Vac-N-Fill) (See: Engine, Cooling and Exhaust/Cooling System/Service and
Repair)Cooling System Draining and Filling (Static Fill) (See: Engine, Cooling and Exhaust/Cooling System/Service and Repair)Cooling System
Draining and Filling (Static Fill LGH, LML) (See: Engine, Cooling and Exhaust/Cooling System/Service and Repair).
