Sierra 2500 Denali 2WD V8-6.0L (2011)
Bosch Connectors (0.64)
Special Tools
*
EL-38125-580 - Terminal Release Tool Kit
*
J-38125-560 - Terminal Release Tool
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment).
Terminal Removal Procedure
1. Locate the lever lock on the wire dress cover. While pressing the lock, pull the lever over and past the lock until the lever is at the end of its travel.
2. Disconnect the connector from the component.
3. Pull the rubber boot that covers the wires back to expose the end of the connector dress cover.
4. Place the connector locking lever in the center of the connector.
5. Locate the 2 dress cover locking tabs that are on the wire end of the connector. Insert a small flat-bladed tool between the cover and connector
body and pry up.
