Sierra 2500 Denali 2WD V8-6.0L (2011)
Tighten the sensor nut to 7 Nm (62 lb in).
Note: Before reinstalling the tire on the wheel, note the following items to avoid tire pressure sensor damage upon tire mounting:
*
Position the mounting/dismounting head 180 degrees from the valve stem.
*
Position the bead transition area 45 degrees counterclockwise of the valve stem.
*
Using the tire machine, rotate the tire/wheel assembly clockwise when transferring the tire bead to the inside of the wheel rim.
*
Repeat items for outer bead.
4. Install the tire on the wheel. Refer to Tire Dismounting and Mounting (See: Wheels and Tires/Tires/Service and Repair/Removal and
Replacement).
Note: A service replacement tire pressure sensor is shipped in OFF mode. In this mode the sensor unique identification code cannot be learned
into the remote control door lock receiver (RCDLR) memory. The sensor must be taken out of OFF mode by spinning the tire/wheel assembly
above 32 km/h (20 mph) in order to close the sensors internal roll switch for at least 10 seconds.
5. Install the tire/wheel assembly on the vehicle. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
6. Lower the vehicle.
7. Learn the tire pressure sensors. Refer to Tire Pressure Indicator Sensor Learn (See: Testing and Inspection).
