Sierra 2500 Denali 2WD V8-6.0L (2011)
5. Using the DT 50291 - installer (2) and the J 8092 - handle (1), turn the wheel hub over and seat the outer bearing assembly against the retaining
ring.
6. Turn the wheel hub over and install the inner bearing cup.
7. Using the DT 50292 - installer (2) and the J 8092 - handle (1), install the inner bearing cup into the wheel hub.
8. Install the inner bearing.
Note: Ensure the seal is fully seated in the hub bore.
9. Using the DT 50289 - installer (2) and the J 8092 - handle (1), install the new oil seal.
10. Install the rotor, if necessary. Refer to Rear Brake Rotor Replacement (JD9) (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor Replacement (JD9))Rear Brake Rotor Replacement (J90, J96) (See:
