Sierra 2500 Denali 2WD V8-6.0L (2011)
Drive/Propeller Shaft: Service and Repair
One-Piece Propeller Shaft Replacement
One-Piece Propeller Shaft Replacement
Removal Procedure
Note: Observe and accurately reference mark all driveline components relative to the propeller shaft and axles before disassembly. These
components include the propeller shafts, the drive axles, the pinion flanges, the output shafts, etc. All components must be reassembled in the
exact relationship to each other as they were when removed. In addition, published specifications and torque values, as well as any measurements
made prior to disassembly must be followed.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Reference mark the propeller shaft (1), the universal joint strap (2), universal bearing cap (4), the drive pinion yoke (5), and the rear axle housing
(6).
3. Remove the bolts (3) and the universal straps (2) from the rear axle pinion yoke (5).
Caution: When removing the propeller shaft, do not attempt to remove the shaft by pounding on the yoke ears or using a tool between the yoke
and the universal joint. If the propeller shaft is removed by using such means, the injection joints may fracture and lead to premature failure of the
joint.
4. Remove the propeller shaft from the rear axle pinion yoke.
