Sierra 2500 Denali 2WD V8-6.0L (2011)
5. Install the propeller shaft (5) to the front axle pinion yoke (1).
Align the reference marks made during removal.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Install the yoke retainers (7) and the bolts (6).
Tighten the yoke retainer bolts to 25 Nm (18 lb ft).
7. Install the boot onto the transfer case output shaft until the boot snaps into the groove on the output shaft.
8. Using the J 43218 to crimp both clamps.
9. Lower the vehicle.
Rear Propeller Shaft Replacement
Rear Propeller Shaft Replacement
Removal Procedure
Note: Observe and accurately reference mark all driveline components relative to the propeller shaft and axles before disassembly. These
components include the propeller shafts, the drive axles, the pinion flanges, the output shafts, etc. All components must be reassembled in the
exact relationship to each other as they were when removed. In addition, published specifications and torque values, as well as any measurements
made prior to disassembly must be followed.
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Reference mark the propeller shaft to the rear axle pinion yoke.
