Sierra 3500 2WD V8-6.0L (2008)
1. Release the park brake.
2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling (See: Procedures/Parking Brake Cable Adjuster
Disabling) .
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
4. Disconnect the right park brake cable (1) from the intermediate cable equalizer bar (2).
5. Release the right park brake cable from the frame bracket by compressing the locking tabs and pulling the cable conduit (3) rearward.
6. Release the park brake cable (1) from the rear axle housing cover clip.
7. Remove the park brake cable clip bolt (2).
8. Remove the park brake cable from the cable guides.
9. Remove the brake shoes. Refer to Brake Shoe Replacement (See: Drum Brake System/Brake Shoe/Service and Repair) .
