Sierra 3500 2WD V8-6.0L (2008)
3. Remove the valve lifter guides (210) with the lifters. Note the installed position of the guides. The notched area of the guides is to align with the
locating tab on the engine block.
4. Remove the valve lifters (209, 219) from the guide (210).
Important: The active fuel management lifters are installed into the guide by aligning the notched area of the guide (1) with the raised
surface on the side of the lifter (2).
5. Organize or mark the components so that they can be installed in the same location from which they were removed, if required.
6. Clean and inspect the valve lifters, if required. Refer to Valve Lifters and Guides Cleaning and Inspection (RPO LY2/LY6/L92) (See: Service and
Repair/Overhaul)Valve Lifters and Guides Cleaning and Inspection (RPO LH6/LMG/LY5/LC9/L76) (See: Service and Repair/Overhaul) .
Installation Procedure
Important:
*
When reusing valve lifters, install the lifters to their original locations.
*
Each of the 4 valve guide assemblies will contain 2 active fuel management valve lifters and 2 non active fuel management valve lifters.
*
With the lifters and guides properly installed, cylinders 1, 4, 6, and 7 lifter bores will each contain 2 active fuel management valve lifters.
