Sierra 3500 2WD V8-6.0L (2008)
Transmission Control Lever Boot Replacement
Transmission Control Lever Boot Replacement
Removal Procedure
1. Remove the transmission control lever. Refer to Transmission Control Lever Knob Replacement (See: Transmission Control Lever Knob
Replacement) .
2. Lift and push the lower edge of the control lever boot as necessary in order to expose the retaining screws
3. Remove the 4 control lever boot retaining screws (2).
4. Carefully release the 4 plastic retainers (3) from the floor and remove the control lever boot retaining bezel (1), boot (4), and retainers (3) as an
assembly.
5. Remove the 4 plastic retainers (3) in order to separate the control lever boot retaining bezel (1) from the boot (4).
6. Remove the control lever insulator (5) from the floor.
Installation Procedure
