Sierra 3500 2WD V8-6.0L VIN U (2004)
9. Remove the rubber cap or plug from the exposed brake hose fitting end.
10. Important:
Install 2 new copper brake hose gaskets.
Assemble the 2 new copper brake hose gaskets and the brake hose inlet fitting bolt to the brake hose.
11. Connect the brake hose at the caliper by installing the brake hose to caliper bolt.
^
Tighten the bolt to 40 Nm (30 ft. lbs.).
12. Bleed the hydraulic brake system.
13. Install the tire and wheel assembly.
14. Lower the vehicle.
15. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
