Sierra 3500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
2. Install the splash shield (15 series).
3. Install the hub and bearing assembly.
4. Install the tire and wheel assembly.
5. Remove the safety stands.
6. Lower the vehicle.
Disc Brake Backing Plate Replacement - Rear
Disc Brake Backing Plate Replacement - Rear (25/35 Series)
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Disable the park brake cable automatic adjuster. Refer to Disabling the Park Brake Cable Automatic Adjuster in Park Brake.
2. Raise and support the vehicle. Refer Vehicle Lifting
3. Remove the tire and wheel assembly.
4. Perform the following procedure to remove the cable (2) from the backing plate (4):
1. Compress the spring (3) by pushing towards the lever (1).
2. Depress the locking tabs.
3. Pull the cable housing out of the backing plate (4).
4. Remove the cable (2) through the slot in the backing plate.
5. Remove the park brake cable (2) from the lever (1).
6. Remove the rotor.
7. Remove the axle shaft.
8. Remove the park brake shoe.
