Sierra 3500 4WD V8-6.0L (2008)
10. Install the propeller shaft universal joint (2) to the pinion yoke (1).
Align the reference marks made during removal.
11. Install the yoke retainers (7) and the yoke retainer bolts (6) to the pinion yoke (1).
Tighten the yoke retainer bolts to 25 N.m (18 lb ft).
12. Inspect the axle lubricant level, and add, if necessary. Refer to Front Axle Lubricant Level Inspection (9.25 Inch Axle) (See: Fluid -
Differential/Service and Repair/Procedures/Front Drive Axle) .
13. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
14. Install the brake calipers. Refer to Front Brake Caliper Replacement (JH6, JH7) Front Brake Caliper Replacement (JD9, JF3, JF7) .
15. Fill the drive axle. Refer to Front Axle Lubricant Replacement (See: Fluid - Differential/Service and Repair/Removal and Replacement/Front
Drive Axle) .
16. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair)
.
17. Lower the vehicle.
