Sierra 3500 4WD V8-6.0L (2008)
10. Measure the torque required in order to rotate the pinion. Use an inch-pound torque wrench. Record the torque value for reassembly. This will
give the combined preload for the following components:
*
The pinion bearings
*
The pinion seal
*
The carrier bearings
*
The axle bearings
*
The axle seals
11. Scribe an alignment line between the pinion shaft and the pinion yoke.
12. Install the J 8614-01 onto the pinion as shown.
13. Remove the pinion nut while holding the J 8614-01 .
