Sierra 3500 4WD V8-6.0L VIN U (2004)
5. Remove all adhesive from the pickup cab panel surface and the back of the emblem/nameplate using 3M(TM) scotch brite molding adhesive
remover disk 3M(TM) P/N 07501 or equivalent.
6. Clean the pickup cab surface using varnish makers and painters (VMP) naptha.
Installation Procedure
1. If the location of the emblem/nameplate has not been marked apply tape, using the dimensions in the graphic.
2. Warm the pickup cab surface with a heat gun J 25070 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the pickup cab panel surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the pickup cab panel to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the pickup cab emblem.