Sierra 3500 4WD V8-6.6L DSL Turbo (2007)
Parking Brake Lever: Service and Repair
Parking Brake Lever Pedal Assembly Replacement
Parking Brake Lever Pedal Assembly Replacement
Removal Procedure
Important: The following service procedure includes the removal of the front park brake cable. The front park brake cable is NOT serviced
separately, but serviced with the park brake pedal assembly.
1. Remove the left side hinge pillar trim panel.
2. Disconnect the park brake warning lamp electrical connector.
3. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling.
4. Remove the bolt and disconnect the park brake pedal release handle from the instrument panel.
5. Without disconnecting the electrical connectors, remove the left side instrument panel electrical center/junction block and position aside. Refer to
Instrument Panel Electrical Center or Junction Block Replacement - Left Side.
6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
7. Disconnect the front park brake cable from the intermediate cable connector by drilling a 3 mm (1/8 in) hole through the dimple in the front to
intermediate park brake cable connector.
8. Release the front park brake cable from the frame by depressing the locking tabs.
9. Lower the vehicle.
