Sierra 3500 4WD V8-6.6L DSL Turbo (2007)
7. Position the fuel filter hose clamp (2) at the fuel feed pipe.
8. Position the engine wiring harness and connect the engine wiring harness electrical connectors (1) to the ECT sensors.
9. Connect the chassis fuel feed pipe quick connect fitting to the fuel feed pipe..
10. Install the generator.
11. Install the intake manifold tube..
12. Install the water outlet tube.
13. Prime the fuel system. Refer to Fuel System Priming.
14. Start the engine. If the engine stalls, repeat the above step.
15. Once the engine starts, inspect for fuel leaks.
Fuel Hose Replacement - Fuel Filter/Heater Element Housing to Fuel Feed Block
Fuel Hose Replacement - Fuel Filter/Heater Element Housing to Fuel Feed Block
Removal Procedure
