Sierra 3500 4WD V8-6.6L DSL Turbo (2007)
8. Install the fuel line bracket to the stud.
9. Install the fuel line bracket nut.
Tighten the nut to 16 N.m (12 lb ft).
10. Connect the fuel feed and return lines.
11. Prime the fuel system. Refer to Fuel System Priming.
12. Start the engine. If the engine stalls, repeat the above step.
13. Once the engine starts, inspect for fuel leaks.
Fuel Injection Fuel Feed Pipe Replacement - Left Side
Fuel Injection Fuel Feed Pipe Replacement - Left Side
Removal Procedure
1. Remove the charge air cooler inlet pipe.
2. Remove the water outlet.
3. Remove the glow plug control module and bracket.
4. Disconnect the chassis fuel feed and return line quick connect fittings from the engine fuel feed and return pipes.
5. Remove the fuel line bracket nut.
6. Remove the fuel line bracket from the stud.