Sierra 3500 4WD V8-6.6L DSL Turbo (2007)
Center Link: Service and Repair
Relay Rod Replacement
Tools Required
J 24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Remove the engine shield, if equipped.
2. Remove the steering linkage shock absorber from the relay rod, if equipped.
Important: Discard the idler arm nut (6) and the pitman arm nut (4).
3. Remove the steering linkage inner tie rods (3).
4. Remove the idler arm nut (6) and separate the idler arm (1) from the relay rod (5) using puller J 24319-B.
5. Remove the pitman arm nut (4) and separate the pitman arm (2) from the relay rod (5) using puller J 24319-B.
6. Remove the relay rod (5) from the vehicle.
7. Inspect the threads and seals on all steering related components. Repair or replace components as needed.
Installation Procedure
