Sierra 3500 4WD V8-6.6L DSL Turbo VIN 2 (2004)
Glow Plug: Service and Repair
Glow Plug - Bank 1
GLOW PLUG REPLACEMENT - BANK 1
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the left wheelhouse panel.
3. Remove the glow plug harness nut(s).
4. Remove the harness from the glow plug(s).
5. Remove the glow plug(s).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the glow plug(s).
Tighten
Tighten the plug to 18 N.m (13 lb ft).
2. Install the harness to the glow plug(s).
3. Install the glow plug harness nut(s).
Tighten
Tighten the nut to 1.7 N.m (15 lb in).
4. Install the left wheelhouse panel.
5. Connect the negative battery cable.
