Sierra 3500 4WD V8-6.6L DSL Turbo VIN 2 (2004)
36. Install F trim valve (3)
37. Install F trim sleeve (4)
38. Align F trim solenoid (7) so that the electrical connection faces up.
39. Install F trim solenoid F. Seat the solenoid.
40. Install solenoid retainer (1).
41. Install O-rings (4) onto G solenoid (3).
42. Install G solenoid (3)
43. Install G solenoid retainer (5) into the bottom of the valve body.
44. Install G solenoid body (2) assembly.
45. Important:
Four bolts pass through the G solenoid valve body to retain the control valve body assembly to the main housing. Install these bolts when installing
the control valve body assembly.
Install the two bolts (1) retaining the G solenoid valve body and the shift valve body to the main valve body.
^
Tighten bolts to 12 Nm (9 ft. lbs.).
46. Align the bolts holes and alignment tabs of pressure switch assembly (1) with the pressure switch assembly holes in main valve body (1).
47. Install pressure switch assembly (1) onto main valve body (3).
48. Install reverse signal tube (2) onto the main valve body.