Sierra 3500 4WD V8-8.1L VIN G (2006)
2. Connect the electrical connector to the fluid level sensor.
Master Cylinder Reservoir Replacement
Master Cylinder Reservoir Replacement
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
1. Apply the park brake and block the wheels.
2. Remove the master cylinder.
3. Drain the master cylinder reservoir.
4. Secure the master cylinder in a vise. Do not clamp the master cylinder body, secure only at the flange.
5. Remove the brake fluid level sensor by carefully depressing the retaining tabs and pushing the sensor through the reservoir.
Carefully remove the reservoir retaining pins.
6. Remove the reservoir from the master cylinder by pulling the reservoir straight up and away from the cylinder.
7. Remove the seals from the master cylinder.
Installation Procedure
1. Inspect the reservoir for cracks or deformation. If found, replace the reservoir.
2. Clean the reservoir with denatured alcohol, or equivalent.
3. Dry the reservoir with non-lubricated, filtered air.
