Sierra 3500 4WD V8-8.1L VIN G (2006)
3. Position the cable clip (2) to the rear axle housing.
Notice: Refer to Fastener Notice.
4. Install the cable clip bolt (1).
Tighten the bolt to 22 N.m (16 lb ft).
5. Install the right cable (3) over the clip on top of the rear axle housing.
6. Install the park brake cable through the frame bracket and guides.
7. Install the right park brake cable (2) to the equalizer.
8. Lower the vehicle.
9. Adjust the park brakes. Refer to Park Brake Adjustment (w/Rear Disc) Park Brake Adjustment (w/Rear Drum).
w/Rear Disc
Park Brake Cable Replacement - Right Rear (Disc Brakes)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Release the park brake.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
