Sierra 3500 4WD V8-8.1L VIN G (2006)
25. Align the following during this procedure:
^
The CV joint boot (3)
^
The CV joint assembly (1)
^
The swage ring (2)
26. Install the top half of J 36652-1 or J 36652-2 onto the lower half of the tool, over the CV joint boot (3) and the CV joint assembly (1).
27. Align the swage ring (2) and the swage ring clamp.
28. Insert the bolts into J 36652-1 or J 36652-2. Hand tighten the bolts until the bolts are snug.
^
Tighten each bolt 180 degrees at a time. Alternate between the bolts until both sides of the top half of the tool touch the bottom half of the
tool.
29. Loosen the bolts and remove the halfshaft assembly from the tool.
