Sierra 3500 Denali 2WD V8-6.0L (2011)
4. Install the rear brake hose bracket bolt (1) and tighten to 22 Nm (16 lb ft).
5. Connect the rear brake crossover pipe fitting (1) and tighten to 25 Nm (18 lb ft).
6. Connect the wheel speed sensor harness clip from the brake hose bracket.
7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair)Hydraulic Brake System Bleeding (Two-mode Hybrid) (See: Brake
Bleeding/Service and Repair).
