Sierra 3500 Denali 2WD V8-6.0L (2011)
Camshaft: Service and Repair
Camshaft Position Actuator Magnet Replacement
Camshaft Position Actuator Magnet Replacement
Removal Procedure
1. Remove the water pump. Refer to Water Pump Replacement (V8) (See: Water Pump/Service and Repair/Water Pump Replacement)Water Pump
Replacement (Diesel) (See: Water Pump/Service and Repair/Water Pump Replacement)Water Pump Replacement (V6) (See: Water
Pump/Service and Repair/Water Pump Replacement).
2. Disconnect the engine harness electrical connector from the camshaft position (CMP) actuator magnet.
3. Remove the CMP actuator magnet bolts (751) and magnet (752).
4. Remove and discard the CMP actuator magnet gasket (753).
Installation Procedure
