Sierra 3500 Denali 2WD V8-6.0L (2011)
Installation Procedure - Cover with Seal
1. Install the J-41479-2A - guide cone and bolts onto the rear of the crankshaft.
2. Install the NEW rear housing gasket (1), rear housing with seal (2), rear housing-to-engine bolts (3) and oil pan-to-rear housing bolts (4).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Tighten the rear housing-to-engine bolts (3) until snug. Do not overtighten.
4. Tighten the oil pan-to-rear housing bolts (4) to 12 Nm (106 lb in).
5. Tighten the rear housing-to-engine bolts (3) to 30 Nm (22 lb ft).
6. Remove the J-41479-2A - guide.
7. Install the automatic transmission flexplate. Refer to Automatic Transmission Flex Plate Replacement (See: Transmission and Drivetrain/Flex
Plate/Service and Repair).
Installation Procedure - Cover without Seal
