Sierra 3500 Denali 2WD V8-6.0L (2011)
3. Install the generator battery jumper cable terminal (1) to the generator stud.
4. Install the generator battery jumper cable nut (2) to the generator.
Tighten the nut to 9 Nm (80 lb in).
5. Position the generator battery jumper cable boot (3).
6. Connect the engine harness electrical connector (3) to the generator.
7. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory (See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts,
Brackets and Accessories/Drive Belt/Service and Repair).
8. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (See: Engine, Cooling and
Exhaust/Engine/Intake Manifold/Service and Repair).
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) (See: Battery/Battery
Cable/Negative/Service and Repair)Battery Negative Cable Disconnection and Connection (TP2) (See: Battery/Battery Cable/Negative/Service
and Repair).
