Sierra 3500 Denali 2WD V8-6.0L (2011)
*
The inner wheel bearing cup
*
The axle hub spindle
2. Install the outer bearing into the wheel hub.
Note: Drive the outer bearing cup into the wheel hub until it is just past the retaining ring groove. Do not bottom out the bearing assembly in the
bore.
3. Using the DT 50290 - installer (2) and the J 8092 - handle (1), install the outer bearing cup into the wheel hub.
Note: Ensure that the retaining ring is fully and evenly seated in the groove.
4. Install the retaining ring into the groove.
Note: Ensure that the outer bearing assembly rotates freely in the hub
