Sierra 3500 Denali 4WD V8-6.0L (2011)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the new EBCM bolts (1) and tighten the bolts in a cross pattern to 3 Nm (27 lb in).
3. Connect the EBCM electrical connector.
4. Program the EBCM and calibrate the brake pressure sensor. Refer to Electronic Brake Control Module Programming and Setup (See: Testing
and Inspection/Programming and Relearning/Electronic Brake Control Module Programming and Setup).
