Sierra 3500 Denali 4WD V8-6.0L (2011)
3. Install the disc brake calliper guide pin seals (1) and boots (2).
4. Ensure the brake caliper guide pin seals and boots are fully seated in the grooves of the brake caliper housing.
5. Install the brake caliper bracket (1) to the disc brake caliper.
6. Ensure the brake caliper guide pin boots are fully seated in the groove of the brake caliper bracket.
7. Install the disc brake pads. Refer to Rear Disc Brake Pads Replacement (JD9) (See: Brake Pad/Service and Repair/Removal and
Replacement/Rear Disc Brake Pads Replacement (JD9))Rear Disc Brake Pads Replacement (J90, J95, J96) (See: Brake Pad/Service and
Repair/Removal and Replacement/Rear Disc Brake Pads Replacement (J90, J95, J96)).
8. Prepare the brake caliper bracket bolts and the rear axle threaded holes for assembly.
*
Thoroughly clean the brake caliper bracket bolts of any threadlocker residue.
*
Thoroughly clean the rear axle threaded holes of any threadlocker residue with denatured alcohol and allow to dry.
9. Apply threadlocker GM P/N 89021297 (Canadian P/N 10953488) to 2/3 of the threaded length of the brake caliper bracket bolt.
10. Allow the threadlocker to cure approximately 10 minutes before assembly.
