Sierra 3500 Denali 4WD V8-6.0L (2011)
14. Ensure the transmission manual shaft is positioned in mechanical park.
15. Install the range selector cable to the range selector cable bracket.
16. Install the retainer securing the range selector cable to the bracket.
17. Install the range selector cable end to the transmission range selector lever stud.
18. Install the range selector cable heat shield.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: Install bolts by hand then mechanically tighten the front bolt first and the rear bolt last. Failure to tighten the bolts in the specified order will
result in misalignment of the heat shield.
19. Install the range selector cable heat shield bolts.
*
Tighten the front bolt to 25 Nm (18 lb ft).
*
Tighten the rear bolt to 25 Nm (18 lb ft).
20. Lower the vehicle.
21. Test the transmission for proper shift operation.
22. If all of the gear positions cannot be achieved, adjust the cable. Refer to Range Selector Lever Cable Adjustment (See: Adjustments/Allison -
Automatic Transmission).
