Sierra 3500 Denali 4WD V8-6.0L (2011)
11. Align the reference marks on the rear axle housing (6), pinion yoke (5), universal bearing cap (4), and the rear propeller shaft (1).
12. Install the straps (2) and the bolts (3).
Tighten the yoke retainer bolts to 25 Nm (18 lb ft).
13. Using the J 43218 , crimp the boot clamps until the dimensions shown are obtained.
14. Remove the support and lower that vehicle.
Propeller Shaft Slip Yoke Boot Replacement
Propeller Shaft Slip Yoke Boot Replacement