Sierra 3500 Denali 4WD V8-6.0L (2011)
7. Using the DT 50292 - installer (2) and the J 8092 - handle (1), install the inner bearing cup into the wheel hub.
8. Install the inner bearing.
Note: Ensure the seal is fully seated in the hub bore.
9. Using the DT 50289 - installer (2) and the J 8092 - handle (1), install the new oil seal.
10. Install the rotor, if necessary. Refer to Rear Brake Rotor Replacement (JD9) (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor Replacement (JD9))Rear Brake Rotor Replacement (J90, J96) (See:
Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor Replacement
(J90, J96))Rear Brake Rotor Replacement (J95) (See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and
Repair/Removal and Replacement/Rear Brake Rotor Replacement (J95)).
11. Apply a light coat of high melting point EP bearing lubricant to the axle housing spindle.