Sierra 3500 Denali 4WD V8-6.0L (2011)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Place the new TFP manifold assembly (2) in position and install one bolt (1) in a recessed location to hold in position. Start the remaining five
bolts (1) in recessed locations and tighten the bolts by hand.
Torque the bolts to 12 Nm (108 lb in).
2. Connect the internal wiring harness connector to the TFP switch.
3. Install the oil pan and transmission internal oil filter. Refer to Oil Pan Replacement (See: Automatic Transmission/Transaxle/Fluid Pan/Service
and Repair/Allison - Automatic Transmission).
Note: The FastLearn, adapt, procedure must be performed. This can be done in 1 step using a scan tool. If this procedure is not done, the TCM
adaptive values will be at the settings that it learned for the old components and will be in slow adaptive mode. Under these conditions, it will take
an unacceptably long time for the adaptive values to converge to levels suitable for the new transmission.
4. Perform the FastLearn procedure. Refer to FastLearn Procedure (See: Automatic Transmission/Transaxle/Testing and Inspection/Programming
and Relearning/Allison - Automatic Transmission).
