Sierra Classic 1500 2WD V8-4.8L (2007)
Seat Cushion: Service and Repair
Rear Seat Cushion Cover and Pad Replacement
Rear Seat Cushion Cover and Pad Replacement
Removal Procedure
1. Remove the rear seat from the vehicle. Refer to Rear Seat Replacement (60/40 Split) Rear Seat Replacement (Extended Cab) Rear Seat
Replacement (Extended Cab w/4th Door) .
2. Remove the rear passenger seat riser.
3. Remove the hog rings and/or the J-clips from the rear edge of the seat cushion cover (3).
4. Disconnect the rear heater connector, if equipped.
5. Remove the seat belt buckles, if required. Refer to Seat Belt Buckle and Latch Replacement - Rear (Crew Cab) Seat Belt Buckle and Latch
Replacement - Rear (Extended Cab) .
6. Remove all of the remaining hog rings, and/or the J-clips that are retaining the seat cushion cover (3) to the seat cushion frame (8).
7. Release the hook, and the loop-strips that are retaining the seat cushion cover to the foam pad (4).
8. Remove the center screw retaining the latch cover, if equipped.
9. Remove the seat cushion cover from the foam pad.
Installation Procedure
1. Install the seat cushion cover to the foam pad.
Notice: Refer to Fastener Notice .
2. Install the center screw retaining the latch cover, if removed.
Tighten the screw to 2 N.m (18 lb in).
3. Engage the hook, and the loop-strips that are retaining the seat cushion cover (3) to the foam pad (4).
4. Install the seat buckles, if removed. Refer to Seat Belt Buckle and Latch Replacement - Rear (Crew Cab) Seat Belt Buckle and Latch
Replacement - Rear (Extended Cab) .
5. Connect the rear heater connector, if equipped.
6. Install the hog rings, and/or the J-clips in order to retain the seat cushion cover to the seat cushion frame (8).