Sierra Classic 1500 2WD V8-5.3L Hybrid (2007)
Notice:
Refer to Power Steering Hose Disconnected Notice.
1. Remove the power steering inlet hose (2) from the power steering pump (1).
2. Remove the power steering inlet hose (2) from the power steering gear (3).
Installation Procedure
1. Connect the power steering inlet hose (2) to the power steering gear (3).
2. Notice:
Refer to Fastener Notice.
Connect the power steering inlet hose (2) to the power steering pump (1).
Tighten the hose connections to 28 Nm (20 ft. lbs.)
3. Bleed the power steering system.
4. Inspect all the hose connections for leaks.
Power Steering Gear Inlet Pipe/Hose Replacement (Without Hydroboost)
Power Steering Gear Inlet Pipe/Hose Replacement (Without Hydroboost)
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the engine protection shield.