Sierra Classic 1500 4WD V8-5.3L (2007)
Notice: Refer to Fastener Notice .
2. Install the recliner arm attachment bolts (2).
Tighten the bolts to 53 N.m (39 lb ft).
3. Install the inboard pivot bolt (1).
Tighten the bolt to 35 N.m (26 lb ft).
4. Install the seat belt retractor. Refer to Seat Belt Retractor Replacement - Left Front or Seat Belt Retractor Replacement - Right Front .
5. Install the lumbar assembly (or power lumbar/bolster assembly if equipped). Refer to Front Seat Lumbar Support Replacement .
6. Install the seat back trim cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement .
7. Connect the lumbar cable (6) underneath the seat cushion (disconnect the wire harness if equipped with power lumbar).
8. Install the seat trim panel. Refer to Front Seat Trim Panel Replacement .
9. Install the head restraint and guides. Refer to Head Restraint Replacement .
10. Install the seat into the vehicle. Refer to Front Seat Replacement - Bucket .
Driver Seat Recliner Handle and Passenger Seat Recliner Handle Replacement
Driver Seat Recliner Handle and Passenger Seat Recliner Handle Replacement
Removal Procedure
1. Remove the screw retaining the recliner handle to the trim panel.
2. Remove the recliner handle.
Installation Procedure