Sierra Classic 1500 4WD V8-5.3L (2007)
Parking Brake Pedal: Service and Repair
Park Brake Pedal Assembly Replacement
Removal Procedure
1. Caution: Refer to Battery Disconnect Caution.
Disconnect the negative battery cable.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. For all 15 series vehicles, relieve the tension from the park brake cable by pulling down on the park brake cable in front of the equalizer then
removing the cables from the equalizer bar.
4. For 25/35 series vehicles, disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling (w/Rear Disc).
5. Remove the safety stands and lower the vehicle.
6. Remove the left side hinge pillar panel.
7. Remove the MID-bussed electrical center from the bracket.
8. Disconnect the park brake warning lamp connection.
