Sierra Classic 1500 4WD V8-5.3L (2007)
3. Notice:
Refer to Fastener Notice.
Install the valve body bolts which retain the internal wiring harness and install the TCC solenoid bolts.
^
Tighten the control valve body bolts to 11 Nm (97 inch lbs.).
^
Tighten the TCC solenoid bolts to 11 Nm (97 inch lbs.).
4. Notice:
Be sure all solenoids are installed with the electrical connectors facing the non-machined (cast) side of the valve body; otherwise, the solenoids
will bind against the transmission case as the valve body bolts are tightened and damage may occur.
Important:
When installing the pressure control solenoid, the electrical connector must be in the position 1 shown. Do not use position 2.
Install the pressure control solenoid (377).
5. Install the pressure control solenoid retainer (378) and retainer bolt (364A).
Tighten the bolt to 11 Nm (97 inch lbs.).
