Sierra Classic 1500 4WD V8-6.0L (2007)
2. Install the right fuel rail cover.
3. Tighten the right fuel rail cover bolts.
Tighten the bolts to 9 Nm (80 inch lbs.).
4. Install the surge tank/heater hoses to the clip on the right fuel rail cover.
5. Install the left fuel rail cover.
6. Tighten the left fuel rail cover bolts.
Tighten the bolts to 9 Nm (80 inch lbs.).
7. Notice: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector.
Loss of engine performance or engine damage may result.
Install the sight shield to the sight shield retainer.
8. Tighten the intake manifold sight shield bolt.
Tighten the bolt to 10 Nm (89 inch lbs.).
