Sierra Classic 2500 2WD V8-6.6L DSL Turbo (2007)
1. Notice:
Refer to Installing Hoses Without Twists or Bends Notice.
Route the hose in the same position the hose occupied prior to removal.
2. Install the power steering gear inlet hose (3) to the power steering pump (1). Hand tighten only.
3. Notice:
Refer to Fastener Notice.
Install the power steering gear inlet hose to the power steering gear.
Tighten both power steering gear inlet hose fittings to 28 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Install the engine protection shield.
6. Lower the vehicle.
7. Bleed the power steering system.
Power Steering Gear Inlet Pipe/Hose Replacement (With Diesel Hydroboost)
Power Steering Gear Inlet Pipe/Hose Replacement (With Diesel Hydroboost)
Removal Procedure
1. Notice:
Refer to Power Steering Hose Disconnected Notice.
Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the LH front tire assembly.
3. Remove the LH wheelhouse panel.
4. Working through the left wheelhouse, loosen the charged air cooler inlet duct clamp (1) at the charged air cooler.
5. Disconnect the charged air cooler from the elbow connection (2) and reposition the left charged air cooler inlet duct for access to the power
